General Accessories | Total Rotor

XT60H Battery Connector Kit

Sold Out

Quality AMASS XT60H battery connectors come pre-soldered with 12AWG gauge soft silicone for direct connection to flight controllers, BEC or 4-in-1 ESC. The sheath at the solder connection provides strain relief for the solder joints and added protection against shorts from damaged insulation near the solder joints that may damage your LiPo batteries. Specifications: Connector AMASS XT60H male with connector sheath Connector Material...

WS2812B LEDs light for flight controller

SGD$2.10

Available in 2 or 4 LEDs version, these mini size LEDs board provide that extra enhancement for your racing drone, connected to LEDs pad which are available on most flight controllers. The LED can be configured through Betaflight of Cleanflight configurators, it can be set for craft orientation, system warnings, arm status, turn indication, lason scanner effect etc Specifications:...

110dB High Output 5V Alarm Buzzer with LED Lights

SGD$5.50

Louder than most standard buzzer's operating at 85dB, this buzzer is super loud at an approximate 110dB output, along with 4 programmable LED lights it is indispensable for locating your lost quad or alerting you of any error. Specifications: Voltage 5V LED 4pcs x WS2812 (programmable thru Betaflight) Size 27mm x 14mm x 11mm Connection flight controller buzzer output Weight 2.9g Mounting 3M mounting...

M5 Low Profile Motor Props Locknut

SGD$4.20

Low profile to reduce the risk of props working loosely; especially when using props with thicker hubs or motors with shorter shaft. Specifications: Size M5 Material Alloy Colour Titanium grey Profile Low Type Self locking Package includes 4 x locknuts

Motors screw set (20pcs)

SGD$4.70

Rubber Vibration Damping Bobbins for Flight Controllers - M2/ M3

SGD$4.20

With the high cycle timing of current flight controllers and powerful motors employed by FPV quad racers, soft mounted flight controllers are almost always required to prevent twitches or oscillations caused by high-frequency vibrations that interfere with accurate gyro reading and PID tunes. These bobbins uses soft but tough rubber damping material to damp out motors, props train and frame's undesirable...

Replacement Sponge for FatShark Goggles Faceplate

SGD$13.20

Improved comfort with the nylon sponge material and special nose bridge design reduces light leakage for pilots with smaller nose bridge. Specifications: Fit HD and Dominator series Attachment Velcro Material Nylon sponge Package includes 1 x grey foam 1 x black foam 2 x backing velcro

FatShark Goggles Straps Black

SGD$8.30

High-Grip Reusable Battery Pad

SGD$1.00

These battery pads provide excellent grip between the battery pack and frame, prevent slippage of LiPo battery mid-flight. To keep the pad contact surface tacky, rinse with water or wipe with a wet cloth. Specifications : Material PU based Gel Colour Clear Size 50mm x 50mm x thickness 3mm Note use scissors to cut to size before peeling the clear protective...

Battery Silicone Anti-Slip Pad

SGD$1.20

These anti-slip battery pads provide grip surface between the battery pack and frame, prevent slippage of LiPo battery mid-flight. To keep the pad contact surface tacky, rinse with water or wipe with a wet cloth. Available in two sizes. Specifications: Material Soft silicone Colour Black Size 65mm x 25mm x 1mm, 100mm x 30mm x 2mm Mounting 3M self-adhesive on...

Total Rotor Battery Strap (5pcs)

SGD$4.00

Battery Protection Plate

SGD$6.20

A complete battery retention kit for racing frames with bottom mounted batteries, it comes with non-slip silica gel pad mounted on carbon fibre plate to keep the battery in place during flight and provides protection when landing. Specifications : Material 3K high strength carbon fibre board Thickness 1.5mm Anti Slip Pad Silicone gel pad with self adhesive Size 42 x...

Products

Frames

Accessories

Electronics

iFlight

Promotion